Elo TouchSystems E221 Manual Página 67
- Página / 107
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
A-72 IntelliTouch/SecureTouch Guide
At minimum, a 2-wire connection is required—the controller's serial output (P2
pin 3) and Signal Ground(P2 pin 9). For two-way communications, the
controller's serial input (P2 pin 5) should also be connected to the host's
Transmit Data pin.
Data Set Ready (DSR) and Clear to Send (CTS) may be used by the host to
verify controller connections and operation. DSR is asserted when power is
applied to the controller and CTS is asserted when the controller's power-on
sequence is complete. For full hardware handshaking, also connect Data
Terminal Ready (DTR) and Request to Send (RTS). Elo drivers typically
require two-way communication and all four handshaking lines.
If accessible, the controller's diagnostic LED can verify whether RS-232 data is
being transmitted.
Alternatively, a breakout box will tell you if there is any activity on the data
line. It is possible that the port you are using on the host computer is meant to
work with an RS-232 DTE device. To check this, install a null modem cable
between the controller and the host computer's serial port. A null modem cable
converts a DCE device into a DTE device by swapping pins 2 and 3 and the
handshaking lines.
P2 Pins DB25 DB9 Host Signal Source
1 8 1 DCD Controller
2 6 6 DSR Controller
3 3 2 RXD Controller
447 RTS Host
523 TXD Host
6 5 8 CTS Controller
7 20 4 DTR Host
8229 RI N/C
9 7 5 GND Common
10 Key
9 7 5 3 1
10 8 6 4 2
- AccuTouch 1
- All rights reserved 2
- Trademark Acknowledgements 2
- List of Figures 4
- FCC Notice 8
- UL Notice 8
- Table of Contents 10
- Index 105 11
- NTRODUCTION 12
- Driver Software 13
- Shipping Damage 13
- Care and Cleaning 14
- Elo Entuitive Touchmonitor 15
- OUCHMONITOR 16
- NSTALLATION 16
- Touchmonitor Configurations 17
- • 2210MX serial controller 17
- • 2201 PC-Bus controller 17
- Touchmonitor Connections 17
- Contents 18
- Installation 18
- Figure 3.2 21
- PC-Bus Controller 22
- Touchscreen Application Tips 23
- Where to Go from Here 25
- OMPONENT 26
- Safety Information 27
- Work Area 27
- Protective Clothing 27
- Getting Started 28
- Figure 4.1 28
- Bezel Design 29
- Installation Steps 30
- Suggested Tools 30
- Disassembling the Display 31
- Removing the Back Case 31
- Discharging the CRT 32
- Removing the CRT 34
- Installing the Touchscreen 35
- Figure 4.3 37
- Transient Protection 41
- Figure 4.4 42
- Controller Interface Options 42
- Internal Controllers 43
- Figure 4.5 43
- External Controllers 48
- Reassembling the Monitor 52
- Sealing the Monitor 53
- ROUBLESHOOTING 56
- Display Problems 57
- Software Troubleshooting 57
- Video Alignment Problems 58
- Hardware Troubleshooting 58
- Touchscreen Diagnosis 60
- 1-2, 4-5 (H-X, Y-L) 61
- 1-4, 2-5 (H-Y, X-L) 61
- Touchscreen Simulation 62
- Figure A.1 63
- Serial Controller 64
- Using the COMDUMP Utility 64
- Byte Description 65
- Byte MSB LSB 65
- Using the TOUCHES Utility 66
- RS-232 Connections 66
- 9 7 5 3 1 67
- 10 8 6 4 2 67
- Power Supply 68
- Figure A.2 68
- Bus Controller 69
- Using the BUSSTAT Utility 69
- Touchscreen Cables 70
- Figure A.3 71
- Transient Protection Circuit 71
- Diagnostic LEDs 71
- 2210 Serial Controller 71
- 3000U USB Controller 72
- 2201 PC-Bus Controller 72
- LED Blink Rate Function 72
- LED State Function 72
- Diagnostic Codes 73
- Bit Value (hex) Description 73
- Figure A.4 74
- ONTROLLER 76
- ONFIGURATION 76
- Jumper Settings 77
- Figure B.1 77
- Figure B.2 78
- E271-2210 Serial Controller 78
- 2201PC-Bus Controller 80
- 2201Emulation Modes 82
- (From Top) 82
- Emulation Mode 82
- PECIFICATIONS 84
- Dust Seal 86
- Watertight Seal 86
- Light Transmission 87
- Environmental 88
- Temperature/Humidity 88
- Temperature 88
- Electrical 89
- Agency Approvals 90
- CE Compliance 91
- OUCHSCREENS 94
- The AccuTouch Touchscreen 95
- Figure 2.1 95
- AccuTouch Touchscreen 95
- The AccuTouch Controllers 97
- Glossary-99 98
- standard 99
- Glossary-101 100
- Glossary-103 102
- Numerics 104
Manuais e produtos relacionados com Monitor tátil Elo TouchSystems E221
Monitor tátil Elo TouchSystems 1247L Especificações
(40 páginas)
(40 páginas)
(34 páginas)
(25 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.040 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais