Elo TouchSystems E221 Manual Página 72
- Página / 107
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
A-77
3000U USB Controller
The 3000U controller has two LED status indicators.
A green LED (D1) indicates controller status as follows:
A second LED (D6) indicates USB status as follows:
2201 PC-Bus Controller
The E271-2201 PC-Bus controller has three diagnostic LED’s. Following
power on, the controller performs its self-test. After the self-test, a flashing
green LED indicates normal operation. If a fatal error was encountered, the
yellow and red LED’s flash an eight-bit error code starting with the most
significant bit, where yellow indicates a binary ‘0” and red a binary ‘1’. See the
SmartSet Touchscreen Controller Family Technical Reference Manual
available at www.elotouch.com/support/dwnldmnls.asp
, or contact Elo
Technical Support for a list of error codes.
During normal operation, the yellow LED indicates controller/host
communication is in progress. For example, when the touchscreen is touched,
the yellow LED should light or flicker (may not be visible with bus controllers
on fast PC’s). If the host does not remove the packet from the controller, the
LED will stay lit.
If the yellow LED lights without a touch, the touchscreen or cabling may be
shorted. Disconnect the touchscreen cable from the controller and cycle power
to the controller to verify this condition.
A constant red LED indicates a warning error condition, such as improper
communication from the host. Suspect the baud rate or other communication
parameters.
LED Blink Rate Function
Once per second Normal condition, untouched state
On continuously Touched state
Twice per second Error detected
LED State Function
OFF Controller is not enumerated on USB
ON Controller is enumerated on USB, but there is no data transfer
Blinking USB data transfers between controller and host are occurring
- AccuTouch 1
- All rights reserved 2
- Trademark Acknowledgements 2
- List of Figures 4
- FCC Notice 8
- UL Notice 8
- Table of Contents 10
- Index 105 11
- NTRODUCTION 12
- Driver Software 13
- Shipping Damage 13
- Care and Cleaning 14
- Elo Entuitive Touchmonitor 15
- OUCHMONITOR 16
- NSTALLATION 16
- Touchmonitor Configurations 17
- • 2210MX serial controller 17
- • 2201 PC-Bus controller 17
- Touchmonitor Connections 17
- Contents 18
- Installation 18
- Figure 3.2 21
- PC-Bus Controller 22
- Touchscreen Application Tips 23
- Where to Go from Here 25
- OMPONENT 26
- Safety Information 27
- Work Area 27
- Protective Clothing 27
- Getting Started 28
- Figure 4.1 28
- Bezel Design 29
- Installation Steps 30
- Suggested Tools 30
- Disassembling the Display 31
- Removing the Back Case 31
- Discharging the CRT 32
- Removing the CRT 34
- Installing the Touchscreen 35
- Figure 4.3 37
- Transient Protection 41
- Figure 4.4 42
- Controller Interface Options 42
- Internal Controllers 43
- Figure 4.5 43
- External Controllers 48
- Reassembling the Monitor 52
- Sealing the Monitor 53
- ROUBLESHOOTING 56
- Display Problems 57
- Software Troubleshooting 57
- Video Alignment Problems 58
- Hardware Troubleshooting 58
- Touchscreen Diagnosis 60
- 1-2, 4-5 (H-X, Y-L) 61
- 1-4, 2-5 (H-Y, X-L) 61
- Touchscreen Simulation 62
- Figure A.1 63
- Serial Controller 64
- Using the COMDUMP Utility 64
- Byte Description 65
- Byte MSB LSB 65
- Using the TOUCHES Utility 66
- RS-232 Connections 66
- 9 7 5 3 1 67
- 10 8 6 4 2 67
- Power Supply 68
- Figure A.2 68
- Bus Controller 69
- Using the BUSSTAT Utility 69
- Touchscreen Cables 70
- Figure A.3 71
- Transient Protection Circuit 71
- Diagnostic LEDs 71
- 2210 Serial Controller 71
- 3000U USB Controller 72
- 2201 PC-Bus Controller 72
- LED Blink Rate Function 72
- LED State Function 72
- Diagnostic Codes 73
- Bit Value (hex) Description 73
- Figure A.4 74
- ONTROLLER 76
- ONFIGURATION 76
- Jumper Settings 77
- Figure B.1 77
- Figure B.2 78
- E271-2210 Serial Controller 78
- 2201PC-Bus Controller 80
- 2201Emulation Modes 82
- (From Top) 82
- Emulation Mode 82
- PECIFICATIONS 84
- Dust Seal 86
- Watertight Seal 86
- Light Transmission 87
- Environmental 88
- Temperature/Humidity 88
- Temperature 88
- Electrical 89
- Agency Approvals 90
- CE Compliance 91
- OUCHSCREENS 94
- The AccuTouch Touchscreen 95
- Figure 2.1 95
- AccuTouch Touchscreen 95
- The AccuTouch Controllers 97
- Glossary-99 98
- standard 99
- Glossary-101 100
- Glossary-103 102
- Numerics 104
Manuais e produtos relacionados com Monitor tátil Elo TouchSystems E221
Monitor tátil Elo TouchSystems 1247L Especificações
(40 páginas)
(40 páginas)
(34 páginas)
(25 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.513 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais